Chigo Split Floor-Standing Air Conditioner Manuel d'utilisateur

1Failure code manual content 一、wall split AC series………… …………………………………………2 二、floor standing AC series………….……………………………………4 三、portable AC series…………..……

10protection 2、Check whether the sensor, connecting wire of the sensor and the detection circuit are abnormal. P5 5 light over heat of compressor t

113、 When the 1 and 2 are both normal, then the components or integrated circuit is damaged, the electric control board should be replaced. F3 outlet

12control should be replaced when it is abnormal. P4 discharge temp. of compressor too high, outside ambient temp. too high, temp. switch of compress

13

2一、wall split AC series LED lamp display code explain code explain failure The reason of fault and solution DF display at on state flicker 1/1 SE

3it is damaged. 6、If the above items are normal, the electric control board should be replaced. E5 PG motor display at off state flicker 5/7 SEC dis

4二、floor standing AC serial LED lamp display code explain code explain failure The reason of fault and solution E2 display at off state flicker 2

5the unit is running. 3、 Check whether the indoor and outdoor wiring is right; when it is wrong, connect them again according to the circuit diagram

6components or integrated circuit is damaged, the electric control board should be replaced. E4 display at off state abnormal protection 1、Check wh

73、 When the 1 and 2 are both normal, then the components or integrated circuit is damaged, the electric control board should be replaced. continuous

8unit fault and socket is well, making sure well contact. 2、Check whether the indoor motor has damaged, the motor should be replaced when it is damag

9board, repair it if there is any above. 3、When the 1 and 2 are both normal, then the components or integrated circuit is damaged, the electric contr